Lights, Wipers and Visibility
Simple checks of your lights, wipers, washer fluid and glass help you see clearly and make your car easier for others to see.
A clear view and working lights deserve attention before a dark evening or rainy drive exposes a problem. These checks are simple enough to fit into an ordinary car-cleaning routine, and most need little more than a few minutes and a helper. Look for changes as well as outright failures: a streak across the windshield, a cloudy headlight lens or a light that no longer works can signal something that needs attention.
Walk Around and Test the Lights
Park somewhere safe and test the lights while someone walks around the car. Check the headlights on low and high beam, brake lights, turn signals and any fog lights fitted to the vehicle. Switch each function on separately so the person checking knows what should be illuminated. Include the center brake light, which is easy to overlook when attention stays on the two main rear light assemblies.
Without a helper, reflections in a garage door, wall or window can help confirm whether lights respond to the controls. Reflections are particularly useful for checking brake lights, but they may not reveal every failed bulb clearly. If anything looks uncertain, arrange a closer check. Keep the car stationary and secure throughout, rather than trying to watch reflections while moving.
Deal With Failed Bulbs and Cloudy Lenses
Replace failed bulbs promptly. Working lights help others recognize your presence and intentions, and many places require them. Consult the owner's manual for the correct replacement and procedure before taking anything apart. If access is difficult or the instructions are unclear, have the light serviced. After replacement, test the affected function again instead of assuming the job is finished.
Also inspect the headlight lenses. Clean off surface dirt so you can tell whether the lens itself has become cloudy. If cloudiness remains, seek advice about suitable restoration or replacement. Pay attention to headlight aim after adding a heavy load: if the beam position changes, check the manual for any adjustment provided for loading or arrange an aim check.
Watch What the Wipers Leave Behind
Wiper blades harden with age, so judge them by how well they clear the windshield. Check their performance on wet glass and look for streaks that remain in your line of sight. A blade that moves normally can still leave an unsatisfactory view. Give the rear wiper the same attention if your car has one.
Clean the glass before deciding whether the blades need replacement, since a dirty windshield makes their performance harder to assess. Replace blades that continue to streak. Use the correct fit for the vehicle and follow the fitting instructions carefully. Once installed, test them with washer fluid to confirm that they clear the glass properly.
Keep Washer Fluid Ready
Check the washer-fluid level regularly and top it up before it runs out. Use the owner's manual to identify the correct reservoir rather than guessing from its location under the hood. Keep suitable washer fluid available so topping up is an easy task.
Test the washers as part of the same check. Fluid in the reservoir is only useful if it reaches the glass. Notice whether the spray covers the windshield where the wipers can spread it. If little or no fluid appears despite an adequate level, investigate the problem rather than repeatedly operating the washers.
Clean Both Sides of the Windshield
Clean the windshield inside and outside. It is easy to wash the exterior and overlook the film or smears on the cabin side. Work across the whole surface, including the edges, then check for marks from the driver's seat.