Tires deserve a regular check even when the car seems to drive normally. Pressure can be wrong without looking obviously low, and tread wear is easier to judge by measuring than by glancing at it. A pressure gauge, a tread depth gauge, and a few minutes of attention can help you catch problems before they become more serious. Make these checks part of your monthly routine and repeat them before a long trip.

Start with cold tires and the correct pressure

Check pressure when the tires are cold, before driving has warmed them up. A reading taken after driving may not give you a useful comparison with the vehicle's recommended cold pressure. If you have just returned from a trip, let the tires cool before checking them.

Find the recommended pressure on the label in the driver's door jamb or in the owner's manual. Use that figure, not the number molded into the tire sidewall, which is not the vehicle's recommended setting. Read the label carefully because the specified pressure may differ between the front and rear tires. If the manual gives different settings for different loads, follow the instructions that match how the car will be used.

Measure each tire, including the spare

Remove the valve cap and press the pressure gauge firmly onto the valve. If air hisses around the connection, reposition the gauge and take another reading. Compare the result with the recommended pressure, then add or release air as needed. Check again after adjusting instead of assuming the tire is now correct.

Work through every tire, even if the first reading is fine. Include the spare if the car has one, checking its specified pressure in the manual or on the relevant label. Replace the valve caps when finished to help keep dirt out of the valves. Under-inflated tires wear more and increase fuel use, so a regular check is useful even when nothing appears wrong.

Measure tread instead of guessing

Tread depth needs a separate check from pressure. Use a tread depth gauge in the tire's main grooves, following the gauge's instructions. Take readings at several points around the tire and across the tread. One measurement can miss an area that has worn more quickly than the rest.

Legal minimum tread depth varies by country. Many countries use 1.6 mm, but check the rule where you drive rather than treating that figure as universal. Tires also have wear bars, small raised sections within the tread grooves. When the surrounding tread has worn level with those bars, it is time for replacement. Do not judge the whole tire by its deepest remaining groove.

Pay attention to uneven wear

Compare the inner edge, center, and outer edge of each tire. Wear that is noticeably heavier in one area deserves attention, even if another part still has plenty of tread. Uneven wear can indicate incorrect pressure or an alignment problem.

Correct the pressure if it is wrong, but do not assume that adjustment explains every wear pattern. Have persistent or pronounced uneven wear checked by a tire professional. Measuring tread regularly also makes it easier to notice a developing difference instead of discovering it only when a tire is badly worn.

Look for damage before finishing

Inspect the tread and visible sidewalls for cuts, bulges, and embedded objects such as nails. A tire can hold air and still need attention. If you find damage or an object lodged in the tire, arrange an inspection rather than relying on its appearance or a normal pressure reading alone.